Large white backlit LCD with enough messages for quick and easy readability and operation. Like, real-time detected room temperature, humidity, and pre-set room temperature and humidity, calculated dew point temperature, working state of water valve, etc.
2 or 3xon/off outputs to control the water valve/humidifier/dehumidifier separately.
Two control modes selectable by users in cooling to control the water valve. One mode is controlled by either room temperature or humidity. The another mode is controlled by either floor temperature or room humidity.
Both temperature differential and humidity differential can be pre-set in order to maintain an optimal control of your hydronic radiant AC systems.
Special design of pressure signal input to control the water valve.
Humidify or dehumidify mode selectable
All pre-set settings can be remembered even energized again after a power failure.
Infrared remote control optional.
RS485 communication interface optional.
Designed to control the room temperature for VAV terminals with 1X0~10 VDC output to cooling/heating or 2X0~10 VDC outputs to cooling and heating dampers. Also one or two relay outputs to control one or two stages electric aux. heater.
LCD can display working status such as room temperature, set point, analog output, etc. Makes reading and operating easy and accurate.
All models feature user-friendly setting buttons
Smart and enough advanced setup makes the thermostat being used in all
Up to two-stage electric aux. heater control makes temperature controlling more accurate and energy-saving.
Large set point adjustment, the mini. and max. limit of temperature preset by end users
Low temperature protection
Celsius or Fahrenheit degree selectable
Cooling/heating mode auto changeover or manual switch selectable
Two parts structure and quick wire terminal blocks make mounting easily.
Infrared Remote Control (optional)
Blue backlight (optional)
Optional Modbus communication interface